BFT PHOBOS N BT Instalační manuál stáhnout pdf (Strana 20)

█ █ █ █ █ █

70 71 72 73 74 75

70 – Common

71 – STOP

72 – SAFE 1 – PHOT (obstruction)

73 – FAULT 1

74 – SAFE 2 – BAR (safety edge)

75 – FAULT 2

Terminal Name Description Default Notes

70 COM Safety positive common common

71 STOP Stop command. STOP Overrides all other commands

72 SAFE 1 Safety input #1. Stops operators during opening, reverses on closing

73 FAULT 1 Supervisory circuit for SAFE 1 FAULT Requires opposite relay state from SAFE 1

74 SAFE 2 Safety input #2. BAR Input for safety edges

75 FAULT 2 Supervisory circuit for SAFE 2 FAULT Requires opposite relay state from SAFE 2

PHOT

SAFETY DEVICES

The Thalia board provides one STOP command input, and

two programmable obstruction sensing device inputs, SAFE1

and SAFE2. All 3 safety inputs are N.C. (normally closed)

contacts. Both SAFE 1 and 2 have a device supervision

circuit labeled FAULT. Fault inputs, when enabled, are all

normally open.

Below is a table with the terminal numbers and its

corresponding functions and default values.

Both SAFE1 and SAFE2 can be programmed to perform any of the following functions under the

LOGIC sub-menu:

RELAY COMMON

RELAY N.C.

POWER 24V +

POWER 24V -

EXAMPLE: SAFETY LOOP DETECTOR OR

SAFETY PHOTO BEAM SENSOR WIRING

VALUE FUNCTION DESCRIPTION

000 System reacts to the input in both opening (stops) and closing (reverses) cycles

001 Same as above. Requires the device to be supervised (FAULT active)

002 System reacts to the input only during the opening cycle (stops)

003 Same as above. Requires the device to be supervised (FAULT active)

004 System reacts to the input only during the closing cycle (reverses)

005 Same as above. Requires the device to be supervised (FAULT active)

006 BAR Safety edge input. It reacts in both opening and closing. Stops and partially reverses.

007 BAR TEST Same as above. Requires the device to be supervised (FAULT active)

008 BAR 8K2

PHOT

PHOT TEST

PHOT OP

PHOT OP TEST

PHOT CL

PHOT CL TEST

Safety edge input with EOL resistor as supervision method.

Safety loop detector

Safety photo-beam sensor

PROGRAMMING: LOGIC > SAFE 1 > 004 (PHOT CL)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře

BFT PHOBOS N BT Instalační manuál Strana 20

Komentáře k této Příručce

Související produkty a manuály pro Zahradní nářadí BFT PHOBOS N BT